Fractal FC-6 - PRESET FUNCTIONS

26
5 FOOTSWITCH FUNCTIONS
PRESET: SELECT BY NUMBER
Creates a footswitch that is “hard-wired” to a specic preset.
For example, a switch that selects Preset 1, or Preset 442.
Preset – Designates the desired Preset by its number on the Axe-Fx III.
€
The LED ring is bright when the designated preset is loaded, otherwise dim.
PRESET: SELECT IN BANK
Creates a footswitch that dynamically maps to a preset within a Bank (see p.24). Using
Select in Bank switches together with Bank Up and Bank Down mimics the way other Fractal
Audio products provide access to hundreds of presets with minimal programming.
Preset – Designates the desired Preset by its position within the bank.
This setting cannot be higher than the global Bank Size setting (see p.24).
€
The LED ring is bright when the designated preset is loaded, otherwise dim.
PRESET: TOGGLE BY NUMBER
“Toggle” functions allow you to switch back and forth between two designated entries.
Primary Preset and Secondary Preset – These set the desired presets by their numbers.
€
The LED ring is bright when you toggle to the “Primary” preset, dim for the “Secondary” and off for “neither”.
PRESET: TOGGLE IN BANK
“Toggle” functions allow you to switch back and forth between two designated entries.
Primary Preset and Secondary Preset – These set the desired Presets by their positions within the bank.
€
The LED ring is bright when you toggle to the “Primary” preset, dim for the “Secondary” and off for “neither”.

“Inc / Dec” functions allow you to scroll through a list, stepping up or down.
Increment/Decrement – Designates the step size, up or down. For example, to create a switch
that goes to the next preset, select +1. For a switch that goes to the previous preset, select -1.
Wrap – Determines whether the list of presets wraps around when you get to the end.
Lower Limit, Upper Limit – These set the lowest and highest preset that can be accessed
using the switch, allowing you to restrict access to only certain presets. If you’re using
UP and DOWN switches, you’ll probably want to set the same limits for both.
€
The LED ring is bright when the switch is active, otherwise dim.
PRESET FUNCTIONS
Default Color: Green