Framery O
2. Pull the body cover outwards and downwards at the same time. Push the lower fold of
the body cover into the lower installation groove.
Note: Align the cover to the door frame. Make sure that there are no gaps
between the body cover and the door frame. Make sure that the body cover is
installed evenly and aligned correctly.
3. If you have installed the power cord to the roof module, cut the notch out of the
remaining body cover.
Note: You only have to do this when installing for the first time.
4. Repeat the steps 1-2 for the right-hand side roof body covers.
48
Complete care instructions
info@frameryacoustics.com
To Next Page
Loading...
