5.0 Software installation
• If you send directly SCPI commands on the GPIB interface,
you don’t need any driver or software.
• If you want a visualization of the operation in course or control manually the devices,
then you need to install the software delivered with the controller.
Hardware- and Software Requirements
You should have the following hardware and software to work with your FC 02:
• PC with Windows NT/2000/XP operating system
• compatible mouse and VGA graphics (min. 800 x 600 pts.).
Installation of FC 02 application software
• Insert the application software CD and click on setup.exe
• Follow the instructions on your screen.
• The installer creates a directory named FC02 where you can doubleclick on FC02.exe to
start the application.
MA_FC02_(Rev2_1) - 9/06 / Version 1 / Rev:2.1
9 / 24
To Next Page
Loading...