Need help?Do you have a question about the Franconia FC 02 and is the answer not in the manual?
General| Brand | Franconia |
|---|---|
| Model | FC 02 |
| Category | Controller |
| Language | English |
Precautions that must be observed before applying power to the instrument.
Requirement for protective earthing of the instrument for safe operation.
Warning against removing instrument covers due to non-serviceable parts inside.
Description of the FC 02 front panel components.
Overview of rear panel connectors and their functions.
Details of the IEEE-488 (GPIB) interface, including standards compliance.
Details of the RS-232 serial port, including baud rate and connector type.
Description of optical input and output ports for device communication.
How to connect devices using optic fibers in the system.
Options for connecting the FC 02 to a computer for control.
Configuration options for automatic operation modes with instrumentation.
Required hardware and software for FC 02 operation.
Step-by-step guide for installing the FC 02 application software.
Introduction to the FC 02 software interface and its main parts.
Description of the turntable control section within the software.
Explanation of menu bar items and their functions.
Detailed explanation of the turntable control interface and parameters.
Setting limits and offsets for turntable movement.
Explanation of target, step, and speed parameters for turntable.
Controls for operating the antenna mast via software.
Setting limits and offsets for antenna mast movement.
Explanation of target, step, and speed for antenna mast.
Overview of program functions like load/save settings and info.
Details of variables in default.set and program menu options.
List and explanation of IEEE 488.2 commands for instrument control.
SCPI commands for instrument selection.
SCPI commands for system configuration and errors.
SCPI commands for status and event registers.
SCPI commands for triggering movements and aborting.
SCPI commands for antenna mast position control.
SCPI commands for turntable angle control.
SCPI commands for clamp line position control.
Explanation of bits in the Status Byte Register.
Explanation of bits in the Event Status Register.
Explanation of bits in the Operation Status Register.
Explanation of bits in the Questionable Status Register.
List and description of SCPI command error codes.
List and description of SCPI executing error codes.
List and description of SCPI device-specific error codes.
List and description of SCPI query error codes.
Technical specifications for the FC 02 unit, including power and dimensions.
To Next Page