F3Dn Service Manual Parts Replacement / Section 2.3
For Technical Support, Call 800-537-2653. Copyright 2005 Franke, Inc. All rights reserved.
Rev. 1 6/06
2.3 Automation Assembly Replacement
Continued: [Part No. 18000567]
19) Tighten all 7/16” [11 mm] bolts securely and recheck
dispense door-to-bottom “kiss” seal for uniform fit.
20) Reattach power service wires to both motors [Red =
positive, black = negative] and sensor leads to Main
Control Board. [See other Lane to verify connections.]
21) Plug in unit power cord to power supply.
22) Test Automation Assembly operation by:
23) Turning on main power switch & pressing LANE-POWER
touch pad on control overlay.
24) If LOAD READY light is on, position empty fry basket
under hopper to activate fry loading cycle, if lane is in
AUTO mode. If in MANUAL mode, press the MANUAL
DISPENSE touch pad.
25) If Lane dispenses fries, it is working properly.
26) Close rear service access panel and return F3Dn
Disperser to normal operating location.
@Tools Required:
Ø 3/8” [10 mm] flat blade
screw driver
Ø 1/8” [3 mm] Allen
Wrench
Ø 7/16” [11 mm] box or
socket wrench
To Next Page
