Franke FCS4050 - Page 66

10 | Configuration Franke Kaffeemaschinen AG
66 User manual SB1200 FM CM
Parameter Value range Remarks
In-line sensor type – Photoelectric sensor
– Flow meter
– Is only displayed in the case of monitoring L: Milk
line or W/L: Inner wall and milk line
– Input of installed sensor type
Empty message 0–40s – Is only displayed in the case of monitoring W: Inner
wall
– Default: 30.0s
Menu item 1.11 Flavor
My settings
1 Set machine
1.11 Flavor
Parameter Value range Remarks
Counting active – Yes
– No
– Yes: Flavor products are counted
– No: Flavor products are not counted
– Default: No
Flavor 1–6
Parameter Value range Remarks
Flavor 1–6 List of syrup types – Only the flavor types stored here will be available
later for the beverage settings
– If User-defined is selected, the flavor types can be
named according to preference
Flavor name 1–6 User-defined Any name can be entered for the flavor types
Note: The manually entered flavor types are not switched
when the language is changed
Only a small amount of
syrup left
0–5000ml – Input of residual amount for which the Syrup type 1–
6 almost empty message appears
– Default: 200ml
Syrup empty 0–5000ml – Input of residual amount for which the Syrup type 1–
6 empty message appears. The syrup type is then
blocked
– Default: 10ml
10.5.3 Menu 2 Set drinks
You can save each product in three user-specific variations. The original cannot be changed.
Only parameters that are relevant for the product are displayed.
The percentage specifications are always based on the preset value.
Tips for configuring the parameters can be found in the chapter Help with problems concerning product quality
[ } 84] .
All values configured in menu 2 are saved in the configuration and can be re-imported.