EasyManuals Logo

Franke Minerva 4-in-1 Electronic User Manual

Franke Minerva 4-in-1 Electronic
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
– 26 –
EN
INSTALLATION
General starting points for installation
Perform the following steps before starting installation.
Stop valves must already be installed.
Close the stop valves.
In existing installations, remove the tap, hoses and boiler if still in place.
Mark the existing cold and hot water connection.
Do not connect the M-Box to a hot water pipe.
There must be two wall plug sockets available for connection.
Installation video
Guide for the standard installation for the 4-in-1:
https://youtu.be/4KPGVG_MoZg
Installation steps
Installing 4-in-1 tap (see page 3)
Installing M-BOX (see page 5)
Installing 5 or 10 litre boiler (see page 7)
Connecting 4-in-1 tap (see page 11)
Connecting 4-in-1 tap with hot water out of existing pipe (see page 13)
Connecting 4-in-1 tap with the Bypass option (see page 14)
Connecting the drain hose (see page 15)
Commissioning (see page 17)

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Franke Minerva 4-in-1 Electronic and is the answer not in the manual?

Franke Minerva 4-in-1 Electronic Specifications

General IconGeneral
BrandFranke
ModelMinerva 4-in-1 Electronic
CategoryWater Heater
Voltage230 V
Frequency50 Hz
Operating Pressure1.5 - 5 bar
Protection RatingIPX4
Water TemperatureAdjustable up to 100°C
Tank Capacity4 Litres
Power1500 W
Safety FeaturesChild Safety Lock
FiltrationYes

Related product manuals