4
Insert Your 4G LTE SIM Card & Battery
Please ensure that a 4G LTE SIM card and a battery have been inserted prior to use.
1. Lift and open the battery cover.
2. Insert the SIM card as shown in the picture below.
3. When inserting the battery, align the battery contacts with the contacts in the battery compartment
and slide the battery into the battery compartment.
4. Replace the cover, and press the four sides of the battery cover until it clicks into each notch.
5. Connect the one end of the USB cable to the travel charger and also connect the other end of the USB
cable to the micro USB port on the bottom side of your 4G LTE Mobile Hotspot.
6. Plug the travel charger into the appropriate electrical outlet to charge the battery. The charging status
LED will be lit red while charging the battery. The LED color will change to green when the battery
is fully charged.
Note: Before you use the device, be sure to charge the battery fully until the charging status LED turns
green.
Important: Only use the batteries and the chargers that have been approved by Franklin Wireless.
The warranty is not valid with any damage caused by other batteries and chargers.
To Next Page
Loading...
