EasyManua.ls Logo

Freewing 80mm A-10 - Battery Installation and CG

Freewing 80mm A-10
17 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Battery size
Before connect the battery and receiver, turn on
your transmitter, select the desired model channel
and make sure the throttle stick is in the lowest
position. We recommend assigning a switch as a kill
switch.
Battery compartment size:
L
=360 W=90 H=90(mm)
BatteryA
Battery B
Velcro A
Velcro B
Battery tray
Screws
(PA3x8 8pcs)
P
ull th
e sticker back
and open the cockpit.
Battery install on the front of
fuselage, and use magic tape to fix.
Canopy/battery hatch door
78mm
(3-1/16")
PNP Assembly instructions
We recommend the following battery capacity and
discharge rate:
6S 22.2V 4000mAh ~ 6S 22.2V 5200mAh (2pcs)
Discharge rate of C
>
30C
Center of gravity
8
A-10 Thunderbolt II
Item No.:FJ311
Place the first battery into the
forward position and secure it
with the velcro strap.
The Center of Gravity is directly related to the flight
characteristics the airplane will demonstrate on it's first flight. As
a starting point, we recommend using 78 mm. Achieve this CG
by moving the batteries. If, for some reason moving the batteries
does not allow you to reach the proper CG, another suitable
material such as sticky backed weight can be utilized.
As you become more accustomed to the airplane, you can adjust
the CG to meet you're individual taste.

Related product manuals