M2 Maintenance Interval Operations for Service Schedules I, II, and III
Maintenance
Operation Number
Operation Description Check
47–02 Fuel Separator Sight Bowl Cleaning and Element Replacement
60–01 Cab Suspension Air Bag Inspection
60–03 Cab Access Stairs Inspection, Argosy COE
60–01 Cab Suspension Air Bag Inspection
72–01 Door Seal, Door Latch, and Door Hinge Lubrication
83–01 Air Conditioner Inspection
83–02 Air Filter Replacement
‡
*
Inspect Meritor Unitized Wheel Ends at 200,000 miles (321 870 km0, then every 50,000 miles (80 470 km).
†
Check the end play at 200,000 miles (321 870 km), then every 200,000 miles (321 870 km).
‡
Replace the HVAC filters every 6 months regardless of mileage.
Table 12, M2 Maintenance Interval Operations for Service Schedules I, II, and III
M2 Maintenance Interval Operations for Service Schedule IV
Maintenance
Operation Number
Operation Description Check
00–04 Lubrication and Fluid Level Check (includes the following):
• Clutch Release Cross-Shaft Lubrication
• Sleeve Assembly Bronze Bushing Lubrication
• Transmission Fluid Level Inspection
• Knuckle Pin Lubrication, Meritor Axles
• Tie Rod Lubrication, Meritor Axles
• Axle Breather and Axle Lubricant Level Inspection
• Driveline Lubrication
• Power Steering Fluid Level Inspection
• Power Steering Gear Lubrication
• Drag Link Lubrication
• Cab Tilt Pump Reservoir Fluid Level and System Check
• Door Seal, Door Latch, and Door Hinge Lubrication
00–06 Perform All M1 Operations
01–01 Engine Noise Panel Inspection (noise emission control)
01–02 Engine Drive Belt Inspection
01–04 Engine-Support Fasteners Check (noise emission control)
09–01 Air Cleaner Element Inspection and Replacement
15–01 Alternator, Battery, and Starter Check
20–01 Pressure Relief Cap Check
26–03 Manual Transmission Air Filter/Regulator Check, Cleaning, or Replacement
General Information00
M2 Maintenance Interval Operations: 00–07
Century Class Trucks Maintenance Manual, January 200700/12
To Next Page
Loading...
