To Return the Hood
1.
Grasp the grab handle, and lift the hood to the
45-degree position.
2.
As the hood goes over center, use the bumper
step and grab handle to control the rate of de-
scent to the operating position. See Fig. 3.8.
3.
Make sure the hood is flush with the cowl, then
secure the hood by engaging both hood hold-
down latches.
IMPORTANT: Make sure that both hold-down
latches are fully engaged before operating the
vehicle.
Keyless Security System,
Optional
General Information
The optional Meritor keyless security system is a
complete vehicle security system. If installed, it locks
and unlocks the doors, protects against theft, and
provides security for the driver while sleeping or rest-
ing inside the vehicle.
The system consists of the following components:
•
A hand-held radio frequency transmitter that
looks like a key chain fob. It acts as a remote
control for locking the doors, unlocking the
doors, or placing the system on alert. Each
system allows as many as four different fobs.
See Fig. 3.9.
•
A red system-status LED (light-emitting diode)
mounted on the overhead panel above the
clock. The LED flashes slow or fast to indicate
what state the system is in: armed, alert,
alarmed, or violated. It is off when the system
is disarmed. See Fig. 3.10.
•
A Meritor relay module mounted behind the
right-hand B-pillar electrical compartment door
that arms and disarms the system and pro-
grams the fobs.
•
A program switch on the Meritor relay module
that places the relay module in the learning
mode, which is the only state in which the sys-
tem can learn fob ID codes. The switch is
shown in its normal, or OFF, state (toggle
pointing up). See Fig. 3.11.
•
A security system electronic control module
(ECM), also mounted behind the right-hand
9/07/95 f880328
Fig. 3.8, Hood Tilting
08/30/96
f541289
ALERT
1
2
3
1. ALERT Button
2. LOCK Button
3. UNLOCK Button
Fig. 3.9, Key Chain Fob (radio transmitter)
Vehicle Access
3.7
To Next Page
Loading...
