What causes the drive motor to not run in program mode in my Fri-Jado Kitchen Appliances?
If the drive motor in your Fri-Jado Kitchen Appliances does not run in program mode, check these potential causes: * A capacitor malfunction. Replace the faulty capacitor. * Loose wiring. Tighten any loose wiring. * A main switch malfunction. Inspect and replace the main switch. * A motor malfunction. Replace the defective motor.
Why doesn't my Fri-Jado Kitchen Appliances oven reach the desired temperature?
If the oven temperature in your Fri-Jado Kitchen Appliances does not reach the desired temperature in program mode, it could be caused by: * A safety thermostat malfunction. Replace the safety thermostat. * A PT-500-sensor malfunction. Replace the PT-500 sensor. * An inoperative electronic control. Replace the electronic control.
Why does my Fri-Jado Kitchen Appliances have no display and/or keypad function?
If the display and/or keypad on your Fri-Jado Kitchen Appliances is not functioning, consider the following: * The main breaker might be open. Check and reset the main breaker. * A loose flat cable from the display to the electronic control. Reconnect the loose flat cable. * Fuse F4 (63mA) may be burned. Replace Fuse F4. * The display and/or electronic control might be malfunctioning. Inspect and replace the malfunctioning component.
How to troubleshoot no power to Fri-Jado STG Oven controls?
If there's no power to the oven controls, here's what you can check: * See if the main breaker is open. * Replace Fuse F1 if it's burned. * Inspect the main switch; it might need replacement. * Make sure all wiring is secure.
Why does the main fuse or breaker blow in my Fri-Jado Kitchen Appliances?
If the main fuse or breaker of your Fri-Jado Kitchen Appliances keeps blowing, it could be due to: * Incorrect wiring. Check the wiring for correctness. * A shorted drive motor, blower, or contactor switch. Inspect and replace the faulty component. * A wiring short. Identify and repair any wiring shorts.
How to troubleshoot no power to Fri-Jado Kitchen Appliances oven controls?
If your Fri-Jado Kitchen Appliances oven controls have no power, there are several potential causes: * The main breaker might be open. In this case, check and reset the main breaker. * Fuse F1 could be burned. If so, replace Fuse F1. * The main switch might have a malfunction. You should inspect and replace the main switch. * The security thermostat may have tripped, requiring a reset. * Loose wiring could also be the issue, so tighten any loose wiring.
Why doesn't the countdown clock work on my Fri-Jado Oven?
The countdown clock may not be working because the crystal of the real-time clock is broken. To resolve this, change the power board.
Why does Fri-Jado STG drive motor stop and start intermittently?
The drive motor might be stopping and starting again because the thermal protection has been activated. Allow the motor to cool until the temperature is below 105°C / 220°F.
Why does Fri-Jado STG blower motor stop and start?
The blower motor might be stopping and starting again due to thermal protection activation. Allow the blower motor to cool until the temperature is below 150°C / 302°F.
Why are all heating elements out on my Fri-Jado STG?
If all heating elements are out while the quartz lamp and blowers operate, and the oven cavity is below the set temperature, the possible causes are: * Safety thermostat malfunction: Replace the safety thermostat. * Contactor inoperative: Test the contactor and replace if inoperative. * Power board malfunction: Inspect and replace the power board if necessary. * Wiring loose: Check and secure any loose wiring.
To Next Page
General
