Control panel
Adequate air circulation should be around
the appliance, lacking this leads to
overheating. To achieve sufficient
Wherever possible the back of the product
should not be against a wall to allow suffi-
ventillation and prevent the risk of fire.
Follow the instructions relevant to
installation.
The appliance must not be locate close to
radiators or cookers.
ventilation, follow the instructions relevant
to installation.
Any electrical work required to do the
servicing of the appliance should be
carried out by qualified electrician or
competent person.
This product must be serviced by an
authorized Service Center, and only
genuine spare parts must be used.
1)If the appliance is Frost Free.
2)If the appliance contains freezer compartment.
Service
4
The control panel that controls the
temperature inside the freezer compartment
is located inside the freezer.
: Cancel audible alarm button.
Alarm : High temperature warning neon.
Power : Electrical power indicator.
Super : Super Freeze indicator.
Super Freeze : Super Freeze button.
SUPER FREEZE (Button)
If you need the temperature inside the
freezer to drop quickly, please press this
button and indicator of super will be on. The
unit runs in Super Freezer.
If you need the appliance to stop the mode
of Super Freeze, press the Super Freeze
button again, the Super Freeze indicator will
go out.
Attention! At super freeze mode, the
freezer will automatically quit super freeze
mode after 24 hours, the super indicator will
shut off simultaneity.
ALARM FOR FREEZER
If the electrical supply has been off for any
for any reason, for a long period, and the
inside temperature has warmed up to higher
than -10°C the alarm will operate.
Starting up and temperature regulation
Insert the plug of the connection lead into
the plug socket with protective earth contact.
Setting
turning the temp-
Cold means:
Highest temperature, warmest setting.
Setting Colder means:
Lowest temperature, coldest setting.
Caution:! Please avoid
erature control knob passed the position for
“Cold” or “Colder”.
Important!-Normally we advise you select
setting of Mid, if you want the temperature
warmer or colder please turn the knob to
lower or higher setting accordingly.
When you turn the knob to lower which can
lead to the more energy-saving. Otherwise,
it would result the high energy-consuming.
Important!-High ambient temperatures
(e.g. on hot summer days) and a cold setting
on the temperature regulator (position
Colder) can cause the compressor to run
continuously!
Reason: when the ambient temperature is
high, the compressor must run continuously
to maintain the low temperature in the
appliance.
When temperature falls below -10°C,
High Temperature alarm indicator will go out.
When temperature≥ -10°C, the indicator
light begins to flash, and at the same time,
the alarm sounds 3 times every 10 seconds.
After 2 minutes the alarm will automatically
stop but the High Temperature alarm
indicator will be on but will stop flashing.
To turn the audible alarm off press ，
and the alarm sound will stop but the
High Temperature indicator will stay lit
but will stop flashing.
(button)
Make sure that the mains plug is
accessible after the installation of the
appliance.
To Next Page
Loading...
