8
After everything is dry place appliance
back into service.
The compartment of this appliance is
“frost free”.
This means that there is no buildup of
frost when it is running, neither on the
internal walls nor on the foods.
Go out of use for a long time
Remove all refrigerated packages.
Remove the mains plug or switch off or
disconnect the electricity supply.
Clean thoroughly (see section: Cleaning
and Care)
Leave the door open to avoid the build up
of odors.
What to do if…
Warning! Before trouble shooting,
disconnect the power supply. Only a
qualified electrician of competent
person must carry out the trouble shooting
that is not in the manual.
Important! There are some sounds during
n o rm a l u s e ( co m p re s s o r, r e f ri g e ra n t
circulation)
Important!
Repairs to refrigerators/freezers may only
be performed by competent service
engineers. Improper repairs can give rise to
significant hazards for the user. If your
appliance needs repairing, please telephone
0845 050 8536
Defrosting
The food is too warm.
Temperature is not properly
adjusted.
Door was open for an
extended period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Please look in the “initial Start Up”
section.
Open the door only as long as
necessary.
Turn the temperature regulation
to a colder setting temporarily.
Please look in the “installation
location” section.
Problem Possible cause Solution
Appliance does not
work.
Appliance is too cold.
Appliance is not switched on.
Mains plug is not plugged in or
is loose.
Fuse has blown or is defective.
Socket is defective.
Temperature is set too cold.
Switch on the appliance.
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature regulator to
a warmer setting temporarily.
The absence of frost is due to the
continuous circulation of cold air inside
t he c o m p a rt m en t , d r iv e n b y a n
automatically controlled fan.
To Next Page
Loading...
