50 PB
Remove the chassis
1. Remove the EntryGard™ Screws. (Refer to Figure 504)
2. Hold the cabinet stationary then carefully slide the unit out
of the sleeve. Make sure to fully support the unit. (Refer to
Figure 505)
Install the Chassis
1. Carefully team lift the chassis and set it into the cabinet.
(Refer to Figure 504)
2. Slide the chassis into the cabinet
4. Reinstall the EntryGard™ screws.. (Refer to Figure 505)
WARNING
ELECTRIC SHOCK HAZARD
Disconnect power to the unit before
servicing. Failure to follow this warning
could result in serious injury or death.
Figure 505 (Remove Chassis)
Figure 504 (Remove Entry Gard Screws)
REMOVE AND INSTALL THE CHASSIS
Kuhl Q
To Next Page
Loading...
Need help?
General
