Frigidaire FAC12C2ABJW - Page 16

Fastening the Indoor Unit
1. Pass the piping through the hole in
the wall.
2. Put the upper claw at the back of
the indoor unit on the upper hook of
the insta![ation plate, move the
indoor unit from side to side to see
that it is securely hooked.
3, Piping can easily be made by lifting
the indoor unit with a cushioning
material between the indoor unit
and the walt. Get it out after finish
piping.
4. Push the lower part of the indoor
unit up on the wall, Then move the
indoor unit from side to side, up and
down to check if it is hooked
securely.
Upper hook .\
Lower hook
material