Frigidaire FFLE4033QW - Draining and Pressure Sensor Issues (E21, E31, E32, E35)

162
Replace the Main Control Board and repeat the Diagnostic Cycle to check for any further alarms.
Reconnect the connector and measure approximately
1375Ω ± 10% on the Solenoid Valve wiring connector on
the circuit board side between terminals J20-1 & J20-3,
J18-1& J18-3 and J18-4 & J18-6 (See Fig. 5). Is the
Solenoid Valve wiring ok?
Replace / Repair the wiring and repeat the Diagnostic
Cycle to check for any further alarms.
NO
Y
E
S