Frigoboat MS SERIES - 5.5 Shelves Regulation

Page
23
5. USE INSTRUCTIONS
Fridges & Freezers Boxes
SERIE MS
STAINLESS STEEL
Series
5.5 Shelves regulation
5.6 Light bulb change
5.7 Cleaning
The light bulb is in a stainless steel shell at the top on the
right. On the inetrnal side there is the switching on button.
To change the light bulb, unscrew it and change it with a
new one of the same model.
(Switching off the fridge/freezer before changing the light
bulb)
Check the light bulb voltage:
If it is 12 V, use the light bulb (Cod. G270423)
If it is 24 V, use the light bulb (Cod. G270425)
Before cleaning the fridge/freezer, it is necessary to cut off
the power.
You must clean the fridge/freezer only with warm water,
using a soft cloth.
After having cleaned it, it is possible to give again the power
to the fridge/freezer.
To regulate the shelves in the box there are four indexing
racks (two for each sides), to which must be fastened the
shelves supports (1). It is necessary to fasten the four sup-
ports at the same level, so that the shelf is perfectly hori-
zontal.
To hook the supports to the grill look at the picture on the
right and repeat the operation for each support.
1
1