We suggest using the following sanitising
solution:
Ecolab P3 Topax-san
(4% dilution = 200 ml).
7. MAINTENANCE
ROUTINE MAINTENANCE (INTENDED FOR USER)
The fats present in the ice cream mixtures are ideal fields for the proliferation of bacterial
loads and mould. To eliminate this serious problem, all the parts which come into contact
with the product must be thoroughly washed and sanitized by careful procedures and
using suitable sanitizing products. The stainless and plastic materials used on our
machines, in fact, comply with the strictest international provisions and their special shape
facilitates their washing. However this is not enough to prevent the formation of mould and
bacteria caused by insufficient or incorrect cleaning.
FRIGOMAT recommends thoroughly washing and sanitizing the parts in direct contact with
the product after each work shift and in compliance with hygienic standards in force in the
Country where the machine is installed.
To correctly clean your machine, refer to the following operations:
PREWASHING
• Pour the maximum admitted load of warm
(approximately 50°C) drinking water into the
machine.
• Turn the main selector on “agitation” in order to start
the beater motor and let it run for about 3'. Pull the
drain plug to drain all the wash water. Repeat the
procedure until the water coming out is clear and
clean.
• Pour the maximum load admitted of
cleansing/sanitising solution into the machine.
• Turn the main selector on “agitation” in order to start
the beater motor and let it run for about 15'. Pull the
drain plug to drain all the sanitizing solution.
To Next Page
Loading...
