Froggit WH6000 PRO - Function Temperature; Humidity

22
- Automatic stop after 2 minutes of alarm if no operation is made,
and the alarm is reactivated the next day.
- Pressing the [ALARM / SNOOZE] key to enter the snooze function
will cause the alarm to sound again after 5 minutes
- Pressing and holding the [ALARM / SNOOZE] key for 2 seconds to
stop the alarm
is triggered again the next day.
- Pressing the [ ALARM ] key stops the alarm, and the alarm is
reactivated the next day.
NOTE:
- The snooze function can be used continuously for 24 hours.
- During the snooze time, the alarm icon continues to blink.
FUNCTION TEMPERATURE / HUMIDITY
- The temperature and humidity readings are displayed in the
outdoor and indoor sections (CH).
- Use the [ °C / °F ] slide switch to select the temperature display
unit.
- If the temperature / humidity is below the measuring range, the
measured value displays "Lo". When
temperature / humidity is above the measuring range, the measured
value shows "HI".
COMFORT DISPLAY
The comfort indication is a pictorial indication based on room air
temperature and humidity.
NOTE:
- The comfort indication may vary depending on humidity at the
same temperature.
- There is no comfort indication if the temperature is below 0°C
(32°F) or above 60°C (140°F).
WIRELESS SENSOR SIGNAL RECEPTION
1. The console displays the signal strength for the wireless
sensor(s) as shown in the following table: