Froggit WH3000SE - User Manual

Other manuals for Froggit WH3000SE

Operation Manual82 pages

Operation Manuals41 pages

Questions and Answers

S
Steven HansenAug 4, 2025
How to fix no WiFi connection on Froggit WH3000SE?
- S
  Steven NashAug 4, 2025
  If your Froggit Weather Station isn't connecting to WiFi, check the following: 1. Make sure the WiFi symbol is displayed on the console. 2. Verify your modem's WiFi settings (network name and password) are correct. 3. Ensure the console is plugged into AC power, as it won't connect on battery power alone. 4. Confirm you're using a 2.4 GHz router, as the console doesn't support 5 GHz networks; if you have a dual-band router, disable the 5 GHz band and enable the 2.4 GHz band. 5. The console does not support guest networks.
T
Tammy CookAug 9, 2025
Why is my Froggit Weather Station not reporting data to Wunderground.com?
- T
  Tami JacksonAug 9, 2025
  To fix the issue of data not reporting to Wunderground.com, first, ensure your password or key is correct; it should match the password you registered on Wunderground.com and cannot begin with a non-alphanumeric character. Next, verify your station ID is correct, paying close attention to avoid substituting 'O' for '0' or vice versa. Also, confirm that the date, time, and time zone are correctly set on the console to ensure real-time data reporting. Finally, check your router firewall settings, as the console sends data via Port 80.
L
Lindsey HooverAug 21, 2025
Why does my Froggit Weather Station rain gauge report rain when it is not raining?
- M
  Monica DeanAug 22, 2025
  If your Froggit Weather Station's rain gauge reports rain when it is not raining, ensure you have a stable and level mounting solution. An unstable mounting can cause the tipping bucket to incorrectly increment rainfall.
A
Amanda SchultzAug 27, 2025
How to fix temperature sensor that reads too high on Froggit Weather Station?
- J
  Jason DavisAug 27, 2025
  If the temperature sensor on your Froggit Weather Station reads too high during the daytime, ensure the sensor array is not near heat sources like buildings, pavement, walls, or air conditioning units. You can also use the calibration feature to offset installation issues related to radiant heat sources. Reference Section 6.7.
D
Dylan ShieldsNov 14, 2025
What to do if Froggit WH3000SE Weather Station outdoor sensor array does not communicate to the display console?
- T
  Timothy BrownNov 15, 2025
  If the outdoor sensor array of your Froggit Weather Station isn't communicating with the display console, try the following: * Reset the console by pressing the reset button for 3 seconds with an open-ended paperclip to discharge the voltage. Remove the batteries, cover the solar panel, wait one minute, and then reinsert the batteries. Resync the console with the sensor array about 10 feet away. The LED next to the battery compartment should flash every 16 seconds. * If the LED doesn't flash, replace the batteries in the sensor array, checking for correct polarity. * If the sensor is flashing every 16 seconds, power cycle the console by removing AC power and batteries, waiting 10 seconds, and then reinserting them. This addresses potential communication loss due to interference o...

Summary

Warnings and Cautions

Quick Start Guide

Pre-Installation Checkout and Site Survey

Pre Installation Checkout

Site Survey

Setting Started

Sensor Set Up

Instructions for assembling the various sensor components correctly.

Best Practices for Wireless Communication

Display Console Operation

Initial Console Setup

Steps to power up and initialize the display console for the first time.

Key Functions

Explains the purpose and operation of each button on the console.

Setting Mode Configuration

Guide to basic settings like Beep, DST, Time Zone, and Date.

Alarm mode

Alarm mode setting

Calibration mode

Calibration Order

Other Features

Factory Reset;Clear Memory

Specification

Outdoor Sensor Specifications

Indoor Sensor Specifications

Air Pressure and Power Consumption

Live Internet Publishing

Wi-Fi Connectivity Setup

Guides for connecting the console to your Wi-Fi network.

Mobile Application Setup

Instructions for downloading and configuring the 'WS View' mobile app.

Upload Data to Weather Services

Steps to upload data to Wunderground, Weathercloud, and WOW.

Mobile application - Check WU weather data and graph

Mobile application - Remove or Add WU ID

Registering WeatherUnderground.com through the PC or Mac

Register Your PWS on Weather Underground

Detailed guide for registering an account on Weather Underground via web browser.

Maintenance

Routine Cleaning

Battery Management and Protection

Troubleshooting Guide

Sensor Communication and Accuracy

Resolving communication issues and ensuring sensor accuracy.

Data Upload and WiFi Connectivity

Fixing data reporting problems and WiFi connection issues.

Froggit WH3000SE Specifications

General

Type	Wireless Weather Station
Display	LCD
Temperature Range (Outdoor)	-40°C to +60°C
Humidity Range (Outdoor)	1% to 99%
Humidity Range (Indoor)	1% to 99%
Wind Speed Range	0 to 180 km/h
Rainfall Measurement	0 to 9999 mm
Power Supply (Outdoor Sensor)	2 x AA batteries
Power (Base Station)	5V DC
Connectivity	Wireless
Transmission Frequency	868 MHz
Temperature Range (Indoor)	0°C to 50°C
UV Index Range	0 to 15
Power Supply	USB
Transmission Range	Up to 100 m
Data Update Interval	60 seconds