29
BACKLIGHTING
The backlight of the main unit can be adjusted with the slide switch [
OFF / HI / LO ] to adjust
to set the appropriate brightness:
- Move the slider to the [ HI ] position for brighter backlighting.
- Move the slider to the [ LO ] position to dim the backlight.
- Move the slider to the [ OFF ] position to turn off the backlight.
MAINTENANCE
BATTERY CHANGE
The low battery indicator shows that the batteries need to be
replaced.
TROUBLESHOOTING
Problem Solution
Interruption of connection
(outdoor sensor)
1. make sure that the sensor is
within the transmission range
2. if it still does not work, reset
the sensor and synchronise it
again with
Console.
Interruption of connection
(indoor sensor)
1. make sure that the sensor is
within the transmission range
2. make sure that the displayed
channel is connected to the
channel
Selection on the sensor
3. if it still does not work, reset
the sensor and synchronise it
again with
Console
No WiFi connection 1. pay attention to the WiFi
symbol on the display, it should
always
on.
2. Make sure that you connect to
To Next Page
Loading...
