To Next PageTo Next PageWhat to do if nothing is shown on the display of my Froling Boiler?
If nothing is shown on the display of your Froling Boiler, first, ensure that the main switch is turned on. If it is already on, check whether the FI circuit breaker or line protection is switched on. Finally, inspect the fuse in the controller and replace it if faulty, making sure to note the amperage (10AT).
What to do if my Froling Boiler has excessive temperature?
If your Froling Boiler experiences excessive temperature, allow the temperature to fall below approximately 75°C. Once it has cooled down, you can mechanically reset the STL (high-limit thermostat) by unscrewing the cap and unlocking it by pressing with a screwdriver.
General| Thermal Output (T4 15-22) | 15-22 kW |
|---|---|
| Thermal Output (T4 24-32) | 24-32 kW |
| Thermal Output (T4 35-50) | 35-50 kW |
| Heating Output | 15-50kW |
| Fuel Type | Wood pellets |
| Dimensions (H x W x D) | Varies by model |
| Water Content | Varies depending on model |
Explains the different hazard levels (Danger, Warning, Caution, Notice) used in the documentation to indicate risks.
Outlines crucial safety precautions and guidelines for operating the boiler, including potential risks of incorrect use.
Details the boiler's safety devices, including the "Boiler Off" function, main switch, safety temperature limiter, and safety valve.
Identifies residual risks associated with touching hot surfaces, automatic boiler startup, and the use of non-permitted fuels.
Provides step-by-step instructions for handling emergency situations like system overheating, smell of flue gas, and fire.
Outlines the procedure to follow if the system overheats and safety devices fail, emphasizing specific actions to take.
Details the immediate safety actions required if flue gas is detected in the boiler room, including evacuation and ventilation.
Provides emergency procedures in case of a fire in the system, focusing on immediate safety and contacting emergency services.
Guides on the assembly, installation, and initial startup of the boiler, emphasizing the need for qualified personnel and adherence to instructions.
Explains the process of filling or refilling the fuel store for the boiler, ensuring the use of correct fuels.
Provides instructions on how to heat up the boiler, including critical notices about factory settings.
Offers general advice and safety precautions for performing servicing and maintenance on the boiler.
Details the procedures for inspecting and cleaning the boiler to ensure smooth running and extend its lifespan.
Covers the steps for inspecting critical components like system pressure, safety valve, and geared motors.
Explains how to perform cleaning tasks, specifically focusing on emptying the ash container.
Explains how the boiler indicates faults, warnings, errors, and alarms via the status LED and display messages.
