4.2.2 Cleaning
Emptying the ash container
The ash container must be emptied at appropriate intervals depending on energy
requirements and fuel quality.
If the ash container is full before you check the ash level, the warning “ash box
full, please empty” will appear on the display.
WARNING
When removing the ash container cover during operation:
False air infiltration via the ash screw duct can lead to uncontrolled combustion
and the risk of accidents.
Before checking the ash level / emptying the ash container:
❒ Switch off the boiler by tapping “Boiler off”
➥ The boiler follows the shutdown procedure and switches to "Boiler off"
status.
In “Boiler off” status:
❒
Open the insulated door (A)
❒ Open the side clamps (B) and remove the ash container cover (C)
➥ Note the sticker on the cover of the ash container!
❒ Check the ash level in both chambers
➥ If either of the two chambers is more than two thirds full, empty the ash
container
❒ Open the ash container clamp using the locking lever (D)
❒ Remove the ash container from the boiler (E)
Boiler Servicing
4
Inspection and cleaning
Operating Instructions T4 24-150 | B0830317_en 29
To Next Page
Loading...
Need help?
General