Fronius Acctiva Easy 1202 - Page 29

Hinged mains plug (0° , 45° , 90°)
LCD
Selector switch (depending on charger
type)
Socket for charger lead
Setting the selec-
tor switch
If your charger is equipped with a selector switch, it will be able to perform a number of
different functions (see rating plate).
All device types can be used to charge lead acid batteries with a liquid (lead, Ca, Ca sil-
ver) or fixed (AGM, MF, sealant) electrolyte.
00000000000000
4,010,XXX,XXX
00007432420000
ACCTIVA EASY 6/12
230V / 50-60Hz 24W
6/12V = 3 / 2Aarith
Out:
Art. Nr.:
In:
Chr. Nr.:
AB
6V12V
Always stop charging before you disconnect the charging cable!
Toujours arrêter la charge avant de débrancher le câble de charge!
IP 20
Acctiva Easy 6/12
Battery voltage setting:
Setting A: 12 volts
Setting B: 6 volts
00000000000000
4,010,XXX,XXX
00007432420000
ACCTIVA EASY 12/24
230V / 50-60Hz 43W
12/24V = 3/1,8Aarith
Out:
Art. Nr.:
In:
Chr. Nr.:
AB
12V
24V
Always stop charging before you disconnect the charging cable!
Toujours arrêter la charge avant de débrancher le câble de charge!
IP 20
Acctiva Easy 12/24, Selectiva 1002/2003
Battery voltage setting:
Setting A: 24 volts
Setting B: 12 volts
ACCTIVA EASY 1206
110-230V / 50-60Hz 48W
12V = 2,5 - 4Aarith
Out:
Art. Nr.:
In:
Chr. Nr.:
AB
Always stop charging before you disconnect the charging cable!
Toujours arrêter la charge avant de débrancher le câble de charge!
IP 20
00007432420000
4,010,XXX,XXX
00000000000000
Acctiva Easy 1202, 1204, 1206, 2403
Charging characteristic setting:
Setting A: For charging all lead acid starter batteries
Setting B: Always use setting B to charge stationary batteries
in standby applications (e.g.: emergency power systems) or
in ambient temperatures exceeding 35 °C!
SELECTIVA 1006
110-230V / 50-60Hz 48W
12V = 2,5 - 4Aarith
Out:
Art. Nr.:
In:
Chr. Nr.:
Always stop charging before you disconnect the charging cable!
Toujours arrêter la charge avant de débrancher le câble de charge!
IP 20
4,010,XXX,XXX 00000000000000
00007432420000
Selectiva 1006, 2003
Charging characteristic setting:
Setting A: For charging all lead acid traction batteries
Setting B: Always use setting B to charge stationary batteries
in standby applications (e.g.: emergency power systems) or
in ambient temperatures exceeding 35 °C!
NOTE!
Danger due to selector switch being set incorrectly.
Setting the selector switch incorrectly can result in the following:
Charger displays incorrect test results.
Charger switches to "error"
Battery will not be fully charged.
Vehicle power supply will be damaged (e.g. in back-up mode).
▶
Always set the selector switch to the correct position.
29
EN