Need help?Do you have a question about the Fronius Ohmpilot and is the answer not in the manual?
General| Category | Battery Charger |
|---|---|
| Device | Fronius Ohmpilot |
| Maximum output | 3 kW |
| Phases | 1 |
| Input voltage | 220 - 240 V |
Explains the meaning of Danger, Warning, Caution, and Note safety symbols.
Outlines general safety requirements for personnel and device operation.
Details the primary purpose of the Fronius Ohmpilot for energy management and hot water heating.
Lists the necessary components for operating the Fronius Ohmpilot system.
Explains the process of integrating a Fronius Smart Meter for surplus energy measurement.
Describes the Ohmpilot's functionality and system design considerations.
Provides general criteria and suitable/unsuitable locations for installing the Ohmpilot.
Defines installation orientation and restrictions for environments like stables or greenhouses.
Covers safety, fixings, and steps for mounting the Ohmpilot on a wall.
Explains the general settings for integrating a heat pump via the Ohmpilot menu.
Describes the menu configuration for using an external source for heating purposes.
Explains the menu settings for managing two heating elements in the system.
Describes the menu configuration for two three-phase heating elements.
Explains the menu settings for controlling a circulation pump alongside heating.
Lists connection methods (Modbus, LAN, WLAN) and inverter-Ohmpilot pairing procedures.
Provides instructions for setting up a data connection using Modbus RTU protocol.
Guides users through establishing a wireless connection via the Ohmpilot's access point.
Explains how to connect the Ohmpilot to a network using a LAN cable.
Describes how to connect the Ohmpilot to an existing WLAN network using WPS.
Details steps for manually configuring a WLAN connection through the Ohmpilot's access point.
Describes methods to turn Boost Mode on/off via the user interface or function key.
Explains the meaning of various status indicators and their corresponding device conditions.
Explains how to set up custom heating schedules based on time and minimum temperature.
Lists error codes, their causes, and recommended remedies for troubleshooting Ohmpilot faults.
Presents detailed electrical and operational specifications for the Fronius Ohmpilot device.
Lists test results and compliance with EN60730 standards for device safety and performance.
Covers warranty terms, proper disposal, and applicable standards for the device.
To Next Page
