Choice of location and installation position
Choosing loca-
tion - general re-
marks
Please note the following criteria when choosing a location for the Ohmpilot:
Install only on a solid surface.
Max. ambient temperatures:
0 °C / +40 °C
Relative humidity:
0 - 99%
The airflow within the Ohmpilot is
from the bottom to the top.
If the Ohmpilot is installed in an enclosed space, forced-air ventilation must be
provided to ensure adequate heat dissipation.
NOTE!
Cable length
The maximum cable length from the output of the Ohmpilot to the load (heating
element) must not exceed 5 m.
Choice of loca-
tion
The Ohmpilot is suitable for indoor installation. The housing
satisfies protection class IP 54 and is protected against splash-
ing water on all sides.
In order to minimise heating up of the Ohmpilot, do not expose
it to direct sunlight. Install the Ohmpilot in a protected posi-
tion. The Ohmpilot must only be installed and operated at an
ambient temperature of 0-40 °C.
IMPORTANT! The Ohmpilot must not be installed or used at
altitudes above 2000 m.
Do not install the Ohmpilot:
-
In areas where ammonia, corrosive vapours, acids or salts
are present (e.g. fertiliser stores, ventilation openings from
cattle sheds, chemical plants, tanneries, etc.)
19
To Next Page
Loading...
