Wall mounting
Safety
WARNING!
Danger due to residual voltage from capacitors.
An electric shock can be fatal!
▶
Before opening the device, wait for the capacitors to discharge (15 seconds).
WARNING!
Risk of burns from the heat sink when open.
This can result in personal injury.
▶
Wear suitable protective equipment.
▶
Allow heat sink to cool.
▶
Do not touch the hot heat sink.
IMPORTANT! The IP 54 protection class only applies if the cover is firmly
screwed to the back.
Selecting wall
plugs and screws
IMPORTANT! Different fixings may be required to fit the Ohmpilot, depending
on the type of surface. The fixings are not included in the scope of supply. The
installer is responsible for selecting the right type of fixing. The underlying sur-
face must be load-bearing.
To install the Ohmpilot in masonry, Fronius recommends the use of steel screws
with a diameter of 4 - 6 mm.
Mounting the
Ohmpilot on the
wall
NOTE!
Risk of dirt and moisture on the connections or electronic components
This may result in damage to the Ohmpilot.
▶
When drilling, ensure that terminals and electronic components in the con-
nection area do not become dirty or wet.
1
Undo the 4 screws and remove the
housing cover.
21
To Next Page
Loading...
