Boost Mode
Boost Mode Boost Mode is used to supply the load at the "Heater 1" output with 100% of the
available power for a short time. The dimming level is set to 100% over a maxim-
um period of 4 hours; switching through phases L2 and L3 takes place. This may
result in electricity being sourced from the grid.
Boost Mode can be activated and deactivated by pressing the function key on the
Ohmpilot (see Indications/controls on the device ) or via the user interface.
Settings in the
menu area
Boost Mode, symbolic representation
1
Open the Ohmpilot user interface (see section Establishing the data connec-
tion).
2
Click on the Boost Mode button to activate the function.
3
Click again to deactivate Boost Mode.
43
To Next Page
Loading...
