Fronius Primo 3.0-1 User Manual

5
EN
Safety rules
General The device is manufactured using state-of-the-art technology and according to recognised
safety standards. If used incorrectly or misused, however, it can cause:
- injury or death to the operator or a third party
- damage to the device and other material assets belonging to the operator.
All persons involved in commissioning, maintaining and servicing the device must
- be suitably qualified,
- have knowledge of and experience in dealing with electrical installations and
- read and follow these Operating Instructions carefully.
The Operating Instructions must always be at hand wherever the device is being used. In
addition to the Operating Instructions, attention must also be paid to any generally appli-
cable and local regulations regarding accident prevention and environmental protection.
All safety and danger notices on the device:
- must be in a legible state,
- must not be damaged,
- must not be removed,
- must not be covered, pasted or painted over.
The terminals can reach high temperatures.
Only operate the device if all of its protection devices are fully functional. If the protection
devices are not fully functional, there is a risk of
- injury or death to the operator or a third party
- damage to the device and other material assets belonging to the operator
Any safety devices that are not functioning properly must be repaired by a suitably qualified
technician before the device is switched on.
Never bypass or disable protection devices.
For the location of the safety and danger notices on the device, refer to the "General" sec-
tion in the Operating Instructions for the device.
Before switching on the device, remove any faults that could compromise safety.
This is for your personal safety!
Environmental
conditions
Operation or storage of the device outside the prescribed area will be deemed as "not in
accordance with the intended purpose". The manufacturer shall not be held liable for any
damage arising from such usage.
Qualified service
engineers
The servicing information contained in these Operating Instructions is intended only for the
use of qualified service engineers. An electric shock can be fatal. Do not perform any ac-
tions other than those described in the documentation. This applies even if you are quali-
fied to do so.
All cables and leads must be secured, undamaged, insulated and adequately dimen-
sioned. Loose connections, scorched, damaged or inadequately dimensioned cables and
leads must be immediately repaired by authorised personnel.
Maintenance and repair work must only be carried out by authorised personnel.

Fronius Primo 3.0-1 Specifications

General

Purpose	Solar panel
Efficiency	98 %
Output power	3000 W
Input current	12 A
Input voltage	80 - 1000 V
Output voltage	- V
Input frequency	50 - 60 Hz
Power supply type	Auto
Adjustable output voltage	-
International Protection (IP) code	IP65
Product color	Black, Grey
Built-in display	Yes
Operating temperature (T-T)	-40 - 55 °C

Weight and Dimensions

Depth	204 mm
Width	431 mm
Height	645 mm
Weight	21500 g