Fitting the mounting bracket (standard)
Safety
WARNING!
Danger from incorrect operation and work that is not carried out properly.
This can result in serious personal injury and damage to property.
▶
All the work and functions described in this document must only be carried
out by technically trained and qualified personnel.
▶
Read and understand this document in full.
▶
Read and understand all safety rules and user documentation for this device
and all system components.
Fitting the
mounting bra-
cket (standard)
IMPORTANT!
-
Drill a Ø5.8 mm hole for the mounting bracket and use a reamer to enlarge
the hole so it can accommodate the dowel pin (Ø6G7).
-
The mounting bracket must be fitted using an M8 shoulder screw and an M6
screw.After screwing the mounting bracket in place, another dowel pin (Ø6
mm) must be driven in to secure it.
1
2
3
20
To Next Page
Loading...
