To Next PageTo Next Page
Need help?Do you have a question about the Fronius TPS/i Robotics TWIN Push and is the answer not in the manual?
General| Power Source Type | Inverter |
|---|---|
| Input Voltage | 3 x 400 V |
| Frequency | 50/60 Hz |
| Output Current | 500 A |
| Application | Robotic Welding |
| Protection class | IP23 |
| Wire feed speed range | 0.5 - 25 m/min |
| Type | Welding System |
| Welding Process | MIG/MAG |
| Rated duty cycle | 100% at 40°C |
| Wire diameter range | 0.8 - 1.6 mm |
| Cooling | Water-cooled |
Explains the meaning of safety symbols and warnings used in the document.
Covers hazards like electrical, fumes, sparks, EMF, and required protective measures.
Covers safety measures during setup, transport, and normal operation.
Details mechanical, electrical, and software requirements for the TWIN system.
Explains the basic operation of the TWIN welding process with two wire electrodes.
Lists available TWIN characteristics and prerequisites.
Presents an overview of TWIN welding process combinations and symbols.
Warns about hazards during installation and commissioning, emphasizing trained personnel.
Provides safety warnings and initial troubleshooting steps for common issues.
