EasyManua.ls Logo

Fronius TPS/i - User Manual

Fronius TPS/i
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Fronius prints on elemental chlorine free paper (ECF) sourced from certified sustainable forests (FSC).
/ Perfect Charging / Perfect Welding / Solar Energy
TPS/i Interface Signal Descriptions
EN-US
User information
Signal description
42,0426,0227,EA 021-20052021

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Fronius TPS/i and is the answer not in the manual?

Fronius TPS/i Specifications

General IconGeneral
BrandFronius
ModelTPS/i
CategoryWelding System
LanguageEnglish

Summary

General Information and Safety

Data Types Used

Defines UINT 16 and SINT 16 data types for signal representation.

Interface Connection Behavior

Explains power source response when connected to a robot interface.

Function Availability

Notes variations in function availability due to software updates.

Signal Transmission Time

Illustrates signal timing and transmission delays during operation.

Safety Information

Crucial warnings and safety procedures for correct operation.

Digital Inputs Overview

Basic Control Signals

Welding start, robot ready, and operating mode selection signals.

Process Control Inputs

Gas flow and wire feed/retraction control signals.

Sensing and Simulation Inputs

Touch sensing, simulation, and wire brake signals.

Configuration and Mode Inputs

Job, characteristic, and TWIN mode selection signals.

Analog Inputs

Wire Feed Speed and Corrections

Sets wire feed speed and adjusts arc length/dynamics.

WireSense Edge Detection

Scans component surfaces for precise edge detection.

Wire Length and Process Parameters

Specifies wire feed length and seam number.

Digital Outputs

System Status and Readiness

Reports power source status, warnings, and system readiness.

Welding Process State

Indicates active process, current flow, and robot motion release.

Arc and Signal Monitoring

Monitors arc stability and main current signals.

Output and Status Indicators

Signals for range deviations, process selection, and external outputs.

Related product manuals