Fronius TPS/i - Table of Contents

Table of contents
General 5
Data Types Used 5
Behavior of the Power Source when an Interface is Connected 5
Availability of Functions 5
Signal Transmission Time 6
Safety 6
Digital Inputs 7
Welding start (Welding on) - Single Bit 7
Robot ready (Robot ready) - Single Bit 7
Working mode (Operating mode) - Single Bit 7
Gas on (Gas on) - Single Bit 9
Wire forward (Wire forwards) - Single Bit 9
Wire backward (Wire return) - Single Bit 10
Error reset (Reset error) 10
Touch sensing (TouchSensing) - Single Bit 11
Gas nozzle touch sensing (Gas nozzle position search) - Single Bit 12
Torch blow out (Blow out welding torch) - Single Bit 13
Welding simulation (Welding simulation) - Single Bit 13
Synchropulse on (SynchroPulse on) - Single Bit 13
WireBrake on (Wire brake on) - Single Bit 13
Torchbody Xchange (Change torch body) - Single Bit 13
Teach mode - Single Bit 14
ExtInput 1-8 (External input 1-8) - Single Bit 15
Job number (Job‑number) - Group Input 16
Welding characteristic (Characteristic number) - Group Input 16
Disable process control (Deactivate process-dependent correction) - Group Input 16
Processline select (Process line selection) - Group Input 16
TWIN mode (TWIN operating mode) - Group Input 17
Documentation mode (Documentation mode) - Single Bit 17
WireSense start - Single Bit 18
WireSense break - Single Bit 19
Analog Inputs 20
Wire feed speed command value (Wire speed set value) - Group Input / Analog Input 20
Arclength correction (arc length correction) - Group Input / Analog Input 20
Pulse-/ dynamic correction (Pulse/dynamic correction) - Group Input / Analog Input 21
Wire retract correction (Wire retraction correction) - Group Input / Analog Input 21
Seam number (Seam number) - Group Input / Analog Input 22
Welding speed (Welding speed) - Group Input / Analog Input 22
WireSense edge detection - Group Input / Analog Input 22
Wire forward / backward length (length specification wire threading / wire retraction) - Group Input /
Analog Input
23
Digital Outputs 25
Definition 25
Heartbeat power source (Heartbeat power source) - Single Bit 25
Power source ready (Power source ready) - Single Bit 25
Warning (Warning) - Single Bit 25
Process active (Process active) - Single Bit 26
Current flow (current flow) - Single Bit 26
Robot motion release (Robot motion release) - Single Bit 27
Arc stable/Touch signal (Arc stable/touch signal) - Single Bit 28
Main current signal (Main current signal) - Single Bit 31
Collisionbox active (CrashBox active) - Single Bit 31
Torchbody gripped (Torch body gripped) - Single Bit 31
Command value out of range (Set value out of range) - Single Bit 32
Correction out of range (Correction out of range) - Single Bit 32
Process Bit (Process bit) - Group Output 32
ExtOutput 1-8 (External output 1-8) - Single Bit 32
Touch signal (Touch signal) - Single Bit 33
Characteristic number valid (Characteristic number valid) - Single Bit 33
Sensor Status 1 (sensor status 1) - Single Bit 33
3
EN-US