Fronius TPS/i User Manual

Sensor Status 2 (sensor status 2) - Single Bit 34
Sensor Status 3 (sensor status 3) - Single Bit 34
Wire stick workpiece (Wire stick workpiece) - Single Bit 34
Parameter selection internally (Internal parameter selection) - Single Bit 34
Limitsignal (Limit signal) - Single Bit 35
Main supply status (Mains voltage status) - Single Bit 35
Safety status - Single Bit 35
Twin synchronization active - Single Bit 36
System not ready - Single Bit 36
Notification (Notification) - Single Bit 36
Analog Outputs 37
Welding voltage (Welding voltage) - Group Output / Analog Output 37
Welding current (Welding current) - Group Output / Analog Output 37
Wire feed speed (Wire speed) - Group Output / Analog Output 38
Actual real value for seam tracking (Current actual value for seam tracking) - Group Output / Ana-
log Output
38
Motor current M1 (Motor current M1) - Group Output / Analog Output 40
Motor current M2 (Motor current M2) - Group Output / Analog Output 40
Motor current M3 (Motor current M3) - Group Output / Analog Output 41
Error number (Error number) - Group Output / Analog Output 41
Warning number (Warning number) - Group Output / Analog Output 41
WireSense position (wire position) - Group Output / Analog Output 41
Available Process Images 43
Process Image Types 43
Changing/Assigning Characteristic Numbers/Program Numbers (Retrofit Mode) 43
Information on the Use of the MIG/MAG Standard Manual, TIG, and Electrode Welding Processes 45
MIG/MAG Standard Manual 45
TIG 45
Electrode 45
Arc Break Monitoring 46
Arc Break Monitoring 46
Fronius Data Channel 48
Fronius Data Channel 48
Signal sequence when selected using "Job Mode" operating mode 49
Signal sequence when selected using "Characteristics Mode" operating mode 50
WireSense - more information 52
Process description WireSense (contour detection) 52
Process description WireSense edge detection (edge detection) 53
Signal curve of Edge Detection Mode on a level surface 54
Signal curve of Edge Detection Mode on a slanted surface 56
Signal curve of Sensing Mode for different surface geometries 58
Signal curve of WireSense break (during Sensing Mode) 60
Representation of the possible measurement range 61
Note on ignition timeout (Ignition Timeout) 62
Available signals for component scanning 63
Signal list 63
Limit Monitoring - functions and activation 64
Functions of Limit Monitoring 64
Available function packages 64
Prerequisites for the successful use of Limit Monitoring 65
Switch Limit Monitoring on / off 65
Detailed description of Limit Monitoring 66
Limit Monitoring - details on the individual welding parameters 67
Voltage monitoring 67
Current monitoring 68
Wirefeeder monitoring 68
Welding time monitoring 69
Energy monitoring 71
Setting of the reaction when exceeding or falling below the limits: 72
Setting of the reaction when exceeding or falling below the limits for the motor force 80
Smart Manager + OPT/i Jobs (4,067,002) 85
4

Fronius TPS/i Specifications

General

Brand	Fronius
Model	TPS/i
Category	Welding System
Language	English