Setting of the
reaction when
exceeding or fall-
ing below the lim-
its:
The setting is used for:
- Determination of how the power source reacts when the set limits are exceeded or
not reached
The following reactions are possible:
- Ignore
- Warning
- Error
The following is a description of each reaction.
Reaction when limits are exceeded or undershot = ignore:
- No reaction
- No entry in the logbook
Reaction when limits are exceeded or undershot = Ignore
Reaction when limits are exceeded or undershot = warning:
- Entry is made in the logbook
- The welding parameters affected by exceeding or falling below the limits are marked
in red
72
To Next Page
Loading...
