General options:
-
Language
-
Contrast
-
Time (hh:mm:ss)
Time zone
Daylight saving time/standard time
-
Date (dd:mm:yy)
-
Charging cable length (m)
-
Charging cable cross-section (mm
2
)
-
AC current consumption
-
Unit for temperature values
-
Code for entering the configuration menu activated/deactivated.
-
Time interval for the parameters logged on the USB thumb drive (s).
-
Reset statistics
-
Reset history
Reset Settings
-
With confirmation prompt ("OK?") for further confirmation.
First the screen appears in the basic
settings with display of date and time,
as well as the software version.
1
Use the "Up/Down" buttons to call up the following information:
-
Device serial number as well as serial number and version of the config-
uration memory.
-
PCB for control/power electronics: Hardware version and serial number.
-
Software: Main software, secondary software, primary software and curve
block version.
Enter the configuration menu as follows:
1
Press the "Pause/Start" button.
A prompt for the code appears.
Enter the required code "1511" as fol-
lows:
1
Use the "Up/Down" buttons to enter the first digit of the code.
2
Press the "Menu" button to move to the next digit of the code.
3
Continue as described above until the complete code is entered.
35
EN-US
To Next Page
Loading...
