4
Confirm the entry with the "Pause/Start" button.
The selection of the main menu items
for configuration mode appears.
When selecting a menu item, you may
be prompted to read the Operating In-
structions. Confirm this prompt by
pressing the "Pause/Start" button
again.
Navigate through the configuration menu and its submenus as follows:
1
Use the "Up/Down" buttons to select the desired menu item.
2
Press the "Pause/Start" button to confirm the menu item and confirm any
confirmation prompts (e.g. "OK?") again.
3
If necessary, use the "Up/Down" buttons to make a selection, e.g. "Off/On" or
enter a value.
4
Press the "Pause/Start" button to confirm the entry.
5
If the cursor moves to the next setting or digit after confirming, proceed
again as described in points (3) and (4).
To exit the current menu:
6
Press the "Menu" button to return to the higher-level selection.
The charge settings are explained be-
low by way of an example:
1
Use the "Up/Down" buttons to select the "Charging settings" menu item.
2
Press the "Pause/Start" button to confirm the menu item.
The selection of settings for the "Charging settings" menu item appears:
The display may vary depending on the selection made. If "Pb-WET" has been se-
lected as the type of battery as shown in the illustration - in conjunction with the
36
To Next Page
Loading...
