Fronius Symo 8.2-3-M Service Manual & Spare Parts List

69
EN-US
Tools and measurement devices
General The "Tools and measurement devices" chapter contains an overview and a description of
all the tools needed to properly service the device. This includes the following tools:
- Required tools
- Measuring and inspection equipment
- Auxiliary materials
Tools required - Torx screwdriver, TX20
- Torx screwdriver, TX25
- Slotted screwdriver, 3 mm
- Socket wrench
- Socket wrench insert, 7 mm
- Socket wrench insert, 36 mm
- Flat wrench, 7 mm
- Flat wrench, 36 mm
- Diagonal cutting pliers
- Needle-nosed pliers
- Torque screwdriver with bit insert, 1 - 6 Nm
- Torque ratchet, 1 - 10 Nm
- Allen key, 4 mm
- Allen key, 5 mm
Measuring and In-
spection Equip-
ment
- Digital multimeter
- Equipment for safety inspection
Auxiliary Materi-
als
- Cleaning material (spray, paper)
- Cable ties 102 and 200
- Heat conducting film TPC (42,0300,3054)
- Screw with gasket PT 5x25 (42,0401,4231)

Fronius Symo 8.2-3-M Specifications

General

AC nominal output	8.2 kW
Max. input voltage	1000 V
MPPT voltage range	200 - 800 V
Number of MPPT	2
Protection class	IP65
Frequency	50 / 60 Hz
THD	< 3%
Power factor (cos φac,r)	0.85 - 1 ind./cap.
Efficiency	98.1%
Operating Temperature Range	-25°C to +60°C
Max. apparent AC power	8200 VA
AC nominal voltage	3 x 230 / 400 V