Fronius TransPuls Synergic 5000 Operating Instructions & Spare Parts

121
EN
Briefly press the Store button to change to the job menu
The first vacant program location for the job is indicated.
Select the desired program location with the adjusting dial, or else leave the suggest-
ed program location unchanged
Press and hold the Store button
The left-hand digital display reads “Pro” - the job is stored in the program location you
have just selected.
"PrG" appears on the left-hand digital display to indicate that the job is now stored.
Release the Store button
Briefly press the Store button to exit from the Job menu
The power source switches to the setting selected before the job was stored.
Retrieving a job
Jobs are retrieved in the job mode process.
Use the adjusting dial to select the desired job
2
3
NOTE! If the selected program location already has a job stored in it, then
this existing job will be overwritten with the new job. This action cannot be
undone.
4
NOTE! The parameters from the Setup menu are also stored for each job
with the exception of the following functions:
- Push-pull unit
- Cooling unit switch-off
- Measuring the welding circuit resistance
- Measuring the welding circuit inductivity
5
6
NOTE! Before retrieving a job, make sure that the welding system has been in-
stalled and set up for the job.
1

Fronius TransPuls Synergic 5000 Specifications

General

Brand	Fronius
Model	TransPuls Synergic 5000
Category	AC Power Distribution
Language	English