General
Device concept The TransSteel (TSt) 3000c Pulse power
source is a fully digitized, microprocessor-
controlled inverter power source.
A modular design and ability to easily
extend the system guarantee a high
degree of flexibility. The device is designed
for the following welding processes:
- MIG/MAG pulse welding
- MIG/MAG standard synergic welding
- TIG welding
- Manual metal arc welding
The device has a "Power limitation" safety feature. This means that the power source
can be operated at the power limit without compromising process safety. For details,
refer to the "Welding operations" chapter.
Operating prin-
ciple
The central control and regulation unit of the power sources is coupled with a digital sig-
nal processor. The central control and regulation unit and signal processor control the
entire welding process.
During the welding process, the actual data is measured continuously and the device
responds immediately to any changes. Control algorithms ensure that the desired target
state is maintained.
This results in:
- A precise welding process
- A high degree of reproducibility on all results
- Excellent weld properties.
Application areas The TransSteel 3000c Pulse is used in trade and industry for manual applications with
classical steel and galvanized sheet metal.
The power source is designed for:
- Mechanical and equipment engineering
- Steel construction
- Plant and container construction
- Metal and portal construction
- Rail vehicle construction
- Metalworking trades
Warning notices
on the device
There are warning notices and safety symbols on the power sources. These warning
notices and safety symbols must not be removed or painted over. They warn against
incorrect operation, as this may result in serious injury and property damage.
21
EN-US
To Next Page
Loading...
Need help?
General
