Welding processes, procedures, and welding char-
acteristics for MIG/MAG welding
General In order to process a wide range of materials effectively, various welding processes, pro-
cedures, and welding characteristics are available on the power source.
Brief description
of MIG/MAG
standard syner-
gic welding
MIG/MAG standard synergic
MIG/MAG standard synergic welding is a MIG/MAG welding process covering the entire
power range of the power source with the following arc types:
Dip transfer arc
Droplet transfer occurs in the lower power range during the short circuit.
Intermediate arc
The droplet increases in size at the end of the wire electrode and is transferred in the
mid power range during the short circuit.
Spray arc
A short circuit-free transfer of material in the high power range.
Brief description
of MIG/MAG
pulsed synergic
welding
MIG/MAG pulsed synergic
MIG/MAG pulsed synergic welding is a pulsed arc process with a controlled material
transfer.
In the base current phase, the energy input is reduced to such an extent that the arc
barely burns steadily and the surface of the workpiece is preheated. In the pulsing cur-
rent phase, an accurately timed current pulse guarantees a precise detachment of the
weld material droplet.
This principle guarantees low-spatter welding and precise operation throughout the
entire power range.
Brief description
of SynchroPulse
welding
SynchroPulse is available for the standard synergic and pulsed synergic processes.
The cyclic change of the welding power between two operating points with SynchroPulse
achieves a finely rippled weld appearance and a non-continuous heat input.
25
EN-US
To Next Page
Loading...
Need help?
General
