MIG/MAG welding
Safety
WARNING!
Operating the device incorrectly can cause serious injury and damage to property.
▶
Do not use the functions described here until you have fully read and understood the
Operating Instructions.
▶
Do not use the functions described here until you have fully read and understood all
of the Operating Instructions of the system components, especially the safety rules.
WARNING!
An electric shock can be fatal.
If the power source is connected to the grid during installation, there is a danger of seri-
ous personal injury and property damage.
▶
Only carry out work on the device when the power source's power switch is in the -
O - position.
▶
Only carry out work on the device when the power source has been disconnected
from the grid.
Preparation
1
Connect the water hoses of the welding torch to the corresponding connection sock-
ets on the cooling unit
(when using the cooling unit and water-cooled welding torch)
2
Insert mains plug
3
Set the power switch to - I -:
- All displays on the control panel briefly illuminate
- If present: The cooling unit starts to work
IMPORTANT! Observe the safety rules and operating conditions in the Operating
Instructions for the cooling unit.
Overview MIG/MAG welding is composed of the following sections:
- MIG/MAG synergic welding
- MIG/MAG standard manual welding
- Spot welding and stitch welding
67
EN-US
To Next Page
Loading...
Need help?
General
