MIG/MAG Standard Manual Welding
General The MIG/MAG standard manual welding process is a MIG/MAG welding process with no
synergic function.
Changing one parameter does not result in any automatic adjustments to the other para-
meters. All of the variable parameters must therefore be adjusted individually, as dictated
by the welding process in question.
Available para-
meters
The following parameters are available for MIG/MAG manual welding:
Wire speed
1 m/min (39.37 ipm.) - maximum wire speed, e.g., 25 m/min (984.25 ipm.)
Welding voltageTransSteel 4000 Pulse: 15.5 - 31.5 V
TransSteel 5000 Pulse: 14.5 - 39 V
Arc-force dynamic:
For influencing the short-circuiting dynamic at the instant of droplet transfer
Welding current
Only the actual value is displayed
MIG/MAG stand-
ard manual weld-
ing
1
Press the "Process" button to select the desired welding process:
MIG/MAG standard manual welding
2
Press the "Mode" button to select the desired MIG/MAG mode:
2-step mode
4-step mode
In MIG/MAG standard manual welding, special 4-step mode corresponds to conventional
4-step mode.
72
To Next Page
Loading...
Need help?
General
