Fronius TransSteel 5000 Syn - Page 2

MIG/MAG Synergic Setup menu
1. 2.
Parameter:
Gas pre-ow time
Gas post-ow time
Slope (2-step, special 4-step)
Starting current (2-step, special 4-step)
Final current (2-step, special 4-step)
Starting current duration (2-step)
Final current duration (2-step)
Feeder inching speed
Burn-back eect
Length of wire that is fed before the safety cut-out
trips
Spot welding time / interval welding time
Interval pause time
Restore factory setup
2nd menu level
Cooling unit control
Cooling unit monitoring
Country-specic setting
Mains fuse protection
Welding circuit resistance
Welding circuit inductivity
Real Energy Input
Arc length correction display
Operating points
retrieve:
1x
save:
delete:
MIG/MAG Manual Setup menu
2.
1. 2.
Parameters:
Gas pre-ow time
Gas post-ow time
Feeder inching speed
Burn-back eect
Ignition current
Length of wire that is fed before the safety cut-out
trips
Spot welding time / interval welding time
Interval pause time
Restore factory setup
2nd menu level
Cooling unit control
Cooling unit monitoring
Country-specic setting
Mains fuse protection
Welding circuit resistance
Welding circuit inductivity
Real Energy Input
Arc length correction display
MMA Setup menu
1. 2. 2.
Parameters:
HotStart current
Hot current time
Anti-stick
Restore factory setup
2nd menu level
Welding circuit resistance
Welding circuit inductivity
Exiting the Setup menu
Service parameters
Parameters: Example of display:
Firmware version
Welding program conguration
Current welding program
Motor current for wire drive in A
Arc time
2nd menu level (Service)