What to do if the Fronius Welding System displays 'Ignition time-out'?
If the Fronius Welding System indicates an 'Ignition time-out', it means the current didn't start flowing before the set wire length was fed, and the power source safety cut-out was activated. Try pressing the torch trigger repeatedly. Also, clean the workpiece surface. If the problem persists, increase the time until the safety cut-out is triggered via the level 2 setup menu.
What to do if Fronius TransTig 5000 Welding System shows error 'PE'?
If your Fronius Welding System displays error 'PE', the earth current watchdog has triggered the power source's safety cut-out. To resolve this, switch off the power source, wait 10 seconds, and then switch it back on. If the error continues after several attempts, the provided information is insufficient to resolve this issue.
What to do if Fronius TransTig 5000 tP1 error occurs?
If the Fronius Welding System displays a tP1 error, it indicates overtemperature in the power source's primary circuit. Allow the power source to cool down.
What to do if Fronius TransTig 5000 tP2 error occurs?
If the Fronius Welding System displays a tP2 error, it indicates overtemperature in the power source's primary circuit. Allow the power source to cool down.
What to do if Fronius TransTig 5000 tP3 error occurs?
If the Fronius Welding System displays a tP3 error, it indicates overtemperature in the power source's primary circuit. Allow the power source to cool down.
What to do if Fronius TransTig 5000 tP4 error occurs?
If the Fronius Welding System displays a tP4 error, it indicates overtemperature in the power source's primary circuit. Allow the power source to cool down.
What to do if Fronius Welding System tP5 error occurs?
If the Fronius Welding System displays a tP5 error, it indicates overtemperature in the power source's primary circuit. Allow the power source to cool down.
What to do if Fronius TransTig 5000 Welding System tP6 error occurs?
If the Fronius Welding System displays a tP6 error, it indicates overtemperature in the power source's primary circuit. Allow the power source to cool down.
What to do if Fronius TransTig 5000 tS1 error occurs?
If the Fronius Welding System displays a tS1 error, it indicates overtemperature in the power source's secondary circuit. Allow the power source to cool down.
What to do if Fronius TransTig 5000 tS2 error occurs?
If the Fronius Welding System displays a tS2 error, it indicates overtemperature in the power source's secondary circuit. Allow the power source to cool down.
Details risks from electrical, noise, fume, spark, EMF hazards and required protective actions.
Details displays, indicators, buttons, and operational features of the MagicWave panel.
Details displays, indicators, buttons, and operational features of the TransTig panel.
Guides through powering up, gas cylinder connection, and welding torch connection.
Explains TIG modes, symbols, and key parameters like Is, I1, tdown.
Covers TIG safety, parameters, ignition, end of weld, and special functions.
Covers MMA safety, preparation, hotstart, and anti-stick functions.
Covers basic troubleshooting steps and explanation of displayed service codes.
General| Brand | Fronius |
|---|---|
| Model | TransTig 5000 |
| Category | Welding System |
| Language | English |
To Next Page