20
Options
"Mode" switch
option
Detailed view of "Mode" switch option
The "mode" switch enables the processes
and modes to be selected on site; the "gas
test" and "wire threading" functions can
also be carried out on site.
NOTE!
The "Mode" switch option cannot be used:
► if the wirefeeder is fitted with the VR 4000 digital display.
► on the VR 7000 CMT.
VR 4000 Ci con-
trol panel option
and VR 4000 digi-
tal display option
The wirefeeder can be fitted with the following control panels as an alternative to the
"Standard" control panel:
- VR 4000 Ci control panel
- VR 4000 digital display
Please refer to the installation instructions for a detailed description of the optional control
panels
VR 4000 Ci control panel option VR 4000 digital display option
IMPORTANT! On the VR 7000 CMT, the optional VR 4000 Ci and VR 4000 control panels
are used exclusively to display actual values. Parameters cannot be adjusted via the op-
tional control panels and the RCU 5000i remote control.
To Next Page
Loading...
