Fronius VR 7000 - Connecting Wire-Feed Unit to Power Source; General Connection Procedure; Connecting the Interconnecting Hosepack

29
EN
Connecting wire-feed unit to power source
General The wirefeeder is connected to the power source using the interconnecting hosepack.
For the "CMT" welding process, a special CMT interconnecting hosepack with additional
LHSB cable is required for connecting the VR 7000 CMT to the CMT power source.
Connecting the
wirefeeder to the
power source
WARNING!
Fitting the equipment incorrectly can cause serious injury and damage.
Do not carry out the steps described here until you have read and completely understood
all the operating instructions.
1 2
3 4
* On the VR 7000 CMT only
** LHSB cable, on CMT interconnecting hosepack only
NOTE!
When connecting the interconnecting hosepack, check that
► all connections are connected properly
► all cables, leads and hosepacks are undamaged and correctly insulated.
1
2
3 4