FS N Series - Chapter 6 Installation; Installation Preparation; Verify the Package Contents; Required Tools and Utilities

Chapter 6 Installation
For Technical Support: www.fs.com/service.html11
6.1 Installation Preparation
6.1.1 Verify the Package Contents
Users should prepare the required tools and utilities by themselves.
6.1.2 Required Tools and Utilities
Caution!
Users should prepare the required tools and utilities by themselves.
6.2 Device Installation
6.2.1 Installing the Switch (
N800-32Q as an example
)
The required tools and utilities are shown below:
Cross screwdrivers
Fl
at-blade screwdriver
ESD wrist str
ap
Antistatic uniform
Figure 6-1 N8000-32Q Switch Install Sketch Map on the Rack Using Stocking