Fuji Electric NA0AX06-PT - 2-3 Names and Functions (Analog Input)

2-15
Section 2 Specications
2-3 Names and Functions
2-3-1 Analog input unit (Type: NA0AX06-MR)
(1) Names
The jumper pins in the analog input unit are used to change the analog signal range and digital value range. Therefore, remove
the upper cover and control board when setting the jumper pin.
Pin layout of control board
(When the upper cover is removed)
Pin layout of I/O board
(When the control board is removed)
2) Terminal block
1) Status indication LED
Nameplate
Expansion connector (IN)
Expansion connector (OUT)
3) JP1
2) Terminal block
4) JP3
5) JP5 (CH1)
5) JP5 (CH0)
4) JP2
5) JP8 (CH4)
5) JP9 (CH5)
5) JP7 (CH3)
5) JP6 (CH2)
<Notes on mounting/removing the upper cover and control board>
• When handling the analog unit, remove it from the control panel, turn off the power, and disconnect other units.
• The procedure for handling the upper cover and printed circuit board, see “Appendix 1 Unit Handling Procedure.”
• Before mounting/removing the upper cover or handling the printed circuit board, be sure to eliminate static electricity.